Kitfox service letter #5, elevator control tube advisory |
||||||||||||
|
||||||||||||
|
||||||||||||
|
|
||||||||||||
|
KITFOX
SERVICE LETTER # 5 SUBJECT:
FAB-li & FAB 13 BUSHINGS, ELEVATOR CONTROL TUBE TO:
KITFOX SERIAL NUMBERS 56-112 FROM:
DENNEY AEROCRAFT COMPANY FAB-11
& FAB-13 BUSHINGS:
If the aft elevator tube has not been assembled, follow the instructions
in this letter. Refer to page F-6 step 8. If the length of the smaller
diameter of either the FAB-il or the FAB-13 is less than 9/16” the
first sentence of the NOTE under step 8 should be amended as
follows: Drill 2 #30 holes (180 degrees apart) not less than 3/16” from the end and drill 2 #30 holes not more than 3/8” from the end at 90 degrees from the first set. The above dimensions are for the smaller diameter of FAB-il & FAB-13 only. Use the regular dimensions for the large diameter end of the parts. |
||||||||||||
|
|
||||||||||||
|
||||||||||||
|
||||||||||||
|
||||||||||||
Ultralight
Aircraft News Magazine |
|
|||||||||||
|
Ultralight Aircraft News Web Magazine PO Box 1710 Holland Landing
Ontario Canada L9N 1P2 647-723-8767.
You may link to these pages or print
them out for your own personal use, but no part of this
publication may be copied or distributed, transmitted, transcribed,
stored in a retrieval system, or translated into any human or computer
language, in any form or by any means, electronic, mechanical,
manual, or otherwise, without the written permission of Dave
Loveman.
By copying or paraphrasing the intellectual
property on this site, you're automatically signing a binding contract
and agreeing to be billed $10,000 payable immediately. Copyright Ultralight News - Ultralight Flyer. ulnews@ultralightnews.com. |
||||||||||||
