(2) tubes of 15 1/4" length, 1 1/2" O.D. 0.035" thickness,
4130 steel for upper legs.
(2) tubes of 16 1/2" length, 1 3/8" O.D. 0.058" thickness,
4130 steel for lower legs.
(4) 3"X3" Triangular 4130 steel plates, 0.125" thick, with
holes for bolts.
AN bolts and nuts, with washers.
(2) 3' lengths of 1/2" thick bungee (wrapped 6~7 times).
(4) hose clamps for holding bungees
(2) small 1" thick rubber round washers for insertions between upper
and lower leg.
Procedure: Weld two triangular plates at the lower
ends of upper legs on each side as shown on photo, and insert in gear
sockets of C-II.
For hours and
hours of web video interviews on the world of ultralight
aviation subscribe to the Ultralight Flyer web video magazine -
Only $24.50 U.S. per year gives your access to web video on
ultralight aircraft, ultralight builders, ultralight
manufacturers, designer, accessories and much, much more!
Ultralight
News
PO Box 1710 Holland
Landing Ontario
L9N 1P2 647-723-8767
Airfield
1895 10th line east of Hwy 11 Bradford Ontario
Ultralight Aircraft News Web Magazine PO Box 1710 Holland Landing
Ontario Canada L9N 1P2 647-723-8767.
You may link to these pages or print
them out for your own personal use, but no part of this
publication may be copied or distributed, transmitted, transcribed,
stored in a retrieval system, or translated into any human or computer
language, in any form or by any means, electronic, mechanical,
manual, or otherwise, without the written permission of Dave
Loveman.
By copying or paraphrasing the intellectual
property on this site, you're automatically signing a binding contract
and agreeing to be billed $10,000 payable immediately. Copyright Ultralight News - Ultralight Flyer.
